Previous Article | Next Article ![]()
Journal of Virology, March 2004, p. 2606-2608, Vol. 78, No. 5
0022-538X/04/$08.00+0 DOI: 10.1128/JVI.78.5.2606-2608.2004
Copyright © 2004, American Society for Microbiology. All Rights Reserved.
and Stephen D. Fuller*
Division of Structural Biology, Wellcome Trust Centre for Human Genetics, University of Oxford, Headington, Oxford OX3 7BN, United Kingdom
Received 26 August 2003/ Accepted 14 November 2003
|
|
|---|
|
|
|---|
The virus was produced from GR cells, in which MMTV is endogenous. The cells were grown to confluence, and virus production was induced by overnight incubation in 0.1 µM dexamethasone. The cell supernatant was clarified by 45 min of centrifugation at 3,750 rpm and ultracentrifuged through a 20% sucrose cushion in a Beckman SW28 rotor for 2 h at 26,000 rpm. The pellet was resuspended overnight in TN buffer (25 mM Tris [pH 7.6], 100 mM NaCl) and stored at -20°C. Virus from four consecutive overnight inductions was thawed, pooled, pelleted by 1 h of ultracentrifugation, resuspended in 200 µl of TN buffer, and then separated into 18 fractions by ultracentrifugation into a 20 to 60% sucrose gradient in a Beckman SW41 rotor for 16 h at 40,000 rpm. A visible band indicated the virus-containing fractions. These fractions were pooled, pelleted by a further 4 h of ultracentrifugation, and resuspended in 100-µl TN buffer. Three independent preparations were made. Cryogrids were prepared and cryoelectron microscopy (cEM) was performed as described previously by using a Phillips CM200 FEG operated at 200 kV and a GATAN 626 Cryo-transfer holder (8, 16). cEM permits visualization of the virus in the unfixed, unstained, hydrated state, which eliminates the inherent problems with particle distortion when studying size and morphology by negative stain. The virions displayed classical MMTV morphology (Fig. 1). They are roughly spherical, with prominent glycoprotein knobs. The core is eccentrically located but in many virions is difficult to distinguish. Images were digitized on a UMAX 3000 scanner at 8-µm step size and manipulated by using SPIDER (7) and IMAGIC (14) image processing packages.
![]() View larger version (91K): [in a new window] |
FIG. 1. Two fields of MMTV virions. The range of particle size and core size is illustrated. Large black arrows indicate two cores within one virion. The inset shows a contrast transfer function corrected image taken closer to focus. Small black arrows indicate the two radially arranged densities in the glycoprotein. Scale bar, 200 nm.
|
The virions exhibit prominent glycoprotein knobs on the surface. The spacing between the knobs is approximately 12 nm, which corresponds to about 400 knobs on an average virion or 1,200 copies of surface envelope protein. HIV, in contrast, is believed to have less than 50 copies of surface envelope protein (5, 10). The distance between spikes does not vary visibly with particle size. The knobs appear to have two radially distinct densities (Fig. 1). Radial density profiling was performed on contrast transfer function corrected images (6) by using the Fourier Bessel expansion method described previously (16). Three hundred sixty profiles were averaged for each particle used. Radial density profiles of eight virions were measured, aligned using the peak corresponding to the outer leaflet of the bilayer, and summed. The two densities of the knob are clearly visible at distances of 5.0 and 9.2 nm from the outer leaflet (Fig. 2A). The knob is similar in length to the 9.5 nm observed for HIV-1 (16) and shorter than the 14 nm observed for human foamy virus (15).
![]() View larger version (37K): [in a new window] |
FIG. 2. (A) The radial density profile of the membrane region of mature MMTV. Radial density profiles for eight MMTV virions were aligned and averaged. The two largest peaks correspond to the inner (left) and outer (right) leaflets of the bilayer. Outside the membrane, the glycoprotein consists of two distinct densities. The inset shows the schematic glycoprotein structure (black) with the lipid bilayer (grey), indicating the distances in nanometers between features. (B) A top view of the viral spike obtained by aligning, averaging, and applying threefold symmetry to images of 542 negatively stained spikes. Scale bar, 5 nm.
|
The viral core is eccentrically located. The core is irregularly sized and shaped and is often angular. It is not significantly more electron-dense than the rest of the virion, so interpretation is difficult. Figure 1 illustrates the range of core shapes seen. The dimensions of 117 single cores were measured. The observed ratio of long to short axes varied between 1 and 2.2, with dimensions varying between 45 nm along the short axis to 110 nm along the long axis. The data are inconsistent with a homogeneous population of cores being viewed from different angles and so reflect true variation in structure. The variation appears greater than that observed for HIV or murine leukemia virus (2, 17). Extensive attempts in our laboratory to repeat the isolation and purification of the viral core using the methods described by Cardiff and coworkers (4) were unsuccessful.
cEM permits reliable measurement of virus diameter, avoiding the problems associated with viral membrane collapse when using conventional techniques (11, 17). The diameters of viruses were measured to the outer edge of the lipid bilayer. The three preparations exhibited mean particle diameters of 130 ± 18 nm (n = 150), 129 ± 18 nm (n = 150), and 141 ± 14 nm (n = 300), with virus diameter ranging between 50 and 210 nm. The mean diameter is significantly smaller than that observed after negative staining (180 nm) and similar to that observed after freeze drying (125 nm) (11). Data from preparations 1 and 2 were combined (Fig. 3) and exhibit a size distribution of a breadth similar to that of HIV-1 (2) (Fig. 3). The large range of diameters observed is typical of retrovirus preparations (2, 9, 17). In most retroviruses, the Gag protein shell assembles either at the plasma membrane or on an internal membrane and the lipid bilayer plays a significant role in the assembly process (1). Assembly of Gag protein and nucleic acid in vitro in the absence of a lipid bilayer leads to the production of particles that are more homogeneous in size (16, 18). Betaretroviridae species, in contrast, assemble their Gag protein shells in the cytoplasm. The dramatic range in diameters seen within retrovirus preparations, therefore, does not result solely from the use of the lipid bilayer as an assembly platform.
![]() View larger version (21K): [in a new window] |
FIG. 3. The size distribution of mature HIV-1 (2) and MMTV virions. A histogram of the diameters to the outside of the lipid bilayer for all virions (grey bars) and for the subset of virions for which single cores were clearly distinguished (black bars) is shown.
|
There is no significant correlation between the size of a virion and the apparent size of its core (Fig. 4). This finding implies that upon maturation core growth is not limited by the amount of protein available. Prior to maturation, the amount of Gag present is proportional to the surface area of the virion, meaning that the largest core-containing viruses, with a diameter 1.7 times that of the smallest core-containing viruses, will contain three times as much Gag protein yet produce similarly sized cores. Core growth must either be limited by a template such as the ribonucleoprotein or must proceed until the concentration of CA protein in the virus drops below a certain threshold. In MMTV, the absence of any correlation between number of cores, particle size, and core size suggests that cobudding of independent genome-containing Gag assemblies into the same particle is not the cause of size heterogeneity or of double-core formation.
![]() View larger version (11K): [in a new window] |
FIG. 4. The relationship between virus size and core size. The mean of the long and short axial lengths of the core were plotted against the virus diameter. There is no significant correlation.
|
We acknowledge support from a Wellcome Trust Programme Grant (HH5FE) for this work. J.A.G.B. holds a Wellcome Trust Structural Biology Studentship. S.D.F. is a Wellcome Trust Principal Research Fellow.
Present address: Department of Biology, University of Victoria, Victoria, British Columbia V8W 3N5, Canada. ![]()
|
|
|---|
This article has been cited by other articles:
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Copyright © 2009 by the American Society for Microbiology. For an alternate route to Journals.ASM.org, visit: http://intl-journals.asm.org | More Info»